Filter
Top Products
K2 - 4
Warning of special dangers
Any procedure impairing the safety at the machine must be
refrained from. In particular do not
- reach into the range of knife and clamp, use auxiliary
tools (e. g. material gauge)
- reach into the range between clamp and cutting material
gauge (backgauge with rake) on the machine rear table
- with Autotrim function:
entering the opened table crack to remove residual cuttings.
Only do that with the machine switched off.
- at machines with attached and/or separately installed
peripheral equipment with lifting/swivelling/moving and/or
clamping function:
do not enter or reach into the danger zone during movement
(provide guard rail)
- The knife may only be changed by personnel especially
instructed for this purpose
Electrical energy
Use only original fuses with the specified current rating.
Switch off the machine/plant immediately if trouble occurs in
the electrical system.
Work on the electrical system or equipment may only be
carried out by a skilled electrician himself or by specially
instructed personnel under the control and supervision of
such electrician and in accordance with the applicable
electrical engineering rules.
If provided for in the regulations, the power supply to parts
of machines and plants, on which inspection, maintenance
and repair work is to be carried out must be cut off. Before
starting any work, check the de-energized parts for the
presence of power and ground or short-circuit them in
addition to insulating adjacent live parts and elements.
The electrical equipment of machines/plants is to be inspec-
ted and checked at regular intervals. Defects such as loose
connections or scorched cables must be rectified immedia-
tely.
Necessary work on live parts and elements must be carried
out only in the presence of a second person who can cut off
the power supply in case of danger by actuating the emer-
gency shut-off or main power switch. Secure the working
area with a red-and-white safety chain and a warning sign.
Use insulated tools only.
Before starting work on high-voltage assemblies and after
cutting out the power supply, the feeder cable must be
grounded and components, such as capacitors, short-
circuited with a grounding rod.
Gas, dust, steam and smoke
Carry out welding , flame-cutting and grinding work on the
machine/plant only if this has been expressly authorized, as
there may be a risk of explosion and fire.
Before carrying out welding, flame-cutting and grinding
operations, clean the machine/plant and its surroundings
from dust and other inflammable substances and make sure
that the premises are adequately ventilated (risk of explosi-
on).
Observe any existing national regulations if work is to be
carried out in narrow rooms.
Hydraulic and pneumatic equipment
Work on hydraulic equipment may be carried out only by
persons having special knowledge and experience in
hydraulic systems.
The pneumatic equipment at the machine must only be
connected to plant compressed-air supply system secured
against overpressure.
Check all lines, hoses and screwed connections regularly for
leaks and obvious damage. Repair damage immediately.
Splashed oil may cause injury and fire.
Depressurize all systems sections and pressure pipes
(hydraulic system, compressed-air
system.
Hydraulic and compressed-air lines must be laid and fitted
properly. Ensure that no connections are interchanged. The
fittings, lenghts and quality of the hoses must comply with
the technical requirements.
Oil, grease and other chemical substances
When handling oil, grease and other chemical substances,
observe the product-related safety regulations.
Be careful when handling hot consumables (risk of burning
or scalding)