Filter
Top Products
K6 - 3
e
f
6.0 Knife Change
Knife Change
Mounting the knife
1. Replace cutting stick or turn same over (see page K6 - 5)
2. Turn adjusting cam (e) to the "0 - position" by means of the knife
wrench
3. Screw knife handles (c1) into the black bordered bolt holes (f) of the new
knife
4. Take knife out of the knife box
5. Remove knife handles (c1) and mount knife guard (c)
6. Insert the knife into the knife bar slots (b) and lift it up into the elongated
holes (g; Attention! Mind the clamping resistance of the knife guard)
7. Release knife guard (knife is clamped to knife bar)
8. Screw all knife screws (except screw at the very right-hand side!) slightly
into the lower bolt holes*; do not fasten them!
9. Remove knife guard
10. Slightly screw-in the remaining screws, but do not fasten them!
11. Push the knife at the center screw (h) up to its topmost position by means
of the knife wrench and fasten it
Continuation next page
* See also "Knife Adjustment", page K6 - 4, item 3
d
b
h
g