Filter
Top Products
SmartSwitch Router User Reference Manual 117
Chapter 7: Routing Policy Configuration Guide
Redistributing RIP into RIP
The SSR routing process requires RIP redistribution into RIP if a protocol is redistributed
into RIP.
To redistribute RIP into RIP, enter the following command in Configure mode:
Redistributing RIP into OSPF
RIP routes may be redistributed to OSPF.
To redistribute RIP into OSPF, enter the following command in Configure mode:
Redistributing OSPF to RIP
For the purposes of route redistribution and import-export policies, OSPF intra- and inter-
area routes are referred to as ospf routes, and external routes redistributed into OSPF are
referred to as ospf-ase routes. Examples of ospf-ase routes include static routes, rip
routes, direct routes, bgp routes, or aggregate routes, which are redistributed into an
OSPF domain.
OSPF routes may be redistributed into RIP. To redistribute OSPF into RIP, enter the
following command in Configure mode:
Redistributing Aggregate Routes
The aggregate parameter causes an aggregate route with the specified IP address and
subnet mask to be redistributed.
Note:
The aggregate route must first be created using the aggr-gen command. This
command creates a specified aggregate route for routes that match the aggregate.
To redistribute RIP into RIP.
ip-router policy redistribute from-proto rip
to-proto rip
To redistribute RIP into OSPF.
ip-router policy redistribute from-proto rip
to-proto ospf
To redistribute ospf-ase
routes into rip.
ip-router policy redistribute from-proto
ospf-ase to-proto rip
To redistribute ospf routes
into rip.
ip-router policy redistribute from-proto
ospf to-proto rip