Filter
Top Products
SmartSwitch Router User Reference Manual 51
Chapter 3: IP Routing Configuration Guide
Configuration Examples
Assigning IP/IPX Interfaces
To enable routing on the SSR, you must assign an IP or IPX interface to a VLAN. To assign
an IP or IPX interface named ‘RED’ to the ‘BLUE’ VLAN, enter the following command:
You can also assign an IP or IPX interface directly to a physical port. For example, to
assign an IP interface ‘RED’ to physical port et.3.4, perform the following:
Show ARP entries in routing table.
ip show routes show-arps
Show DNS parameters.
system show dns
ssr(config)# interface create ip RED address-netmask
10.50.0.1/255.255.0.0 vlan BLUE
ssr(config)# interface create ip RED address-netmask
10.50.0.0/255.255.0.0 port et.3.4