Filter
Top Products
SmartSwitch Router User Reference Manual 147
Chapter 8: Multicast Routing Configuration Guide
To start or stop DVMRP, enter one of the following commands in Configure mode:
Configure DVMRP on an Interface
DVMRP can be controlled/configured on per-interface basis. An interface does not have
to run both DVMRP and IGMP together. DVMRP can be started or stopped IGMP starts
and stops automatically with DVMRP.
To enable IGMP on an interface, enter the following command in the Configure mode:
Configure DVMRP Parameters
In order to support backward compatibility, DVMRP neighbor timeout and prune time
can be configured on a per-interface basis. The default neighbor timeout is 35 seconds.
The default prune time is 7200 seconds (2 hours).
To configure neighbor timeout or prune time, enter one of the following commands in
Configure mode:
Configure the DVMRP Routing Metric
You can configure the DVMRP routing metric associated with a set of destinations for
DVMRP reports. The default metric is 1.
To configure the DVMRP routing metric, enter the following command in Configure
mode:
Start DVMRP.
dvmrp start
Stop DVMRP.
no dvmrp start
Enable DVMRP on an
interface.
dvmrp enable interface
<ipAddr>|<interface-name>
Configure the DVMRP neighbor
timeout.
dvmrp set interface
<ip-addr>
neighbor-
timeout
<number>
Configure the DVMRP prune time.
dvmrp set interface
<ip-addr>
prunetime
<number>
Configure the DVMRP routing
metric.
dvmrp set interface
<ip-addr>
metric
<number>