Filter
Top Products
Chapter 9: IPX Routing Configuration Guide
158 SmartSwitch Router User Reference Manual
Create an IPX RIP Access Control List
IPX RIP access control lists control which RIP updates are allowed. To create an IPX RIP
access control list, perform the following task in the Configure mode:
Once an IPX RIP access control list has been created, you must apply the access control list
to an IPX interface. To apply an IPX RIP access control list, enter the following command
in Configure mode:
Monitor an IPX Network
The SSR reports IPX interface information and RIP or SAP routing information.
To display IPX information, enter the following command in Enable mode:
Configuration Examples
This example performs the following configuration:
• Creates IPX interfaces
• Adds static RIP routes
• Adds static SAP entries7.pdf.zip
• Adds a RIP access list
Create an IPX RIP access control list.
acl
<name> permit|deny ipxrip
<FromNetwork>
<ToNetwork>
Apply an IPX RIP access control list.
acl
<name>
apply interface
<Interface Name>
input|output
[logging [on|off]]
Show a RIP entry in the IPX RIP table.
ipx find rip
<DstNetwork>
Show a SAP entry in the IPX SAP table.
ipx find sap
<type>
<ServiceType>
<ServiceName>
<ServerNetwork>
Show IPX interface information.
ipx show interfaces
<interface-name>
Show IPX RIP table.
ipx show tables rip
Show IPX routing table.
ipx show tables routing
Show IPX SAP table.
ipx show tables sap
Show IPX RIP/SAP table summary
ipx show tables summary