Filter
Top Products
Chapter 1: SmartSwitch Router Product Overview
28 SmartSwitch Router User Reference Manual
Here is an example:
In this example, the location “pc-flash” indicates that the SSR is set to use the factory-
installed software on the flash card.
2. Copy the software upgrade you want to install onto a TFTP server that the SSR can
access. (Use the ping command to verify that the SSR can reach the TFTP server.)
3. Use the system promimage upgrade command to copy the boot PROM upgrade onto
the internal memory in the Control Module.
Here is an example:
4. Enter the system show version command to verify that the new boot PROM software
is on the internal memory of the Control Module:
Activate the Configuration Commands in the Scratchpad
The configuration commands you have entered using procedures in this chapter are in the
Scratchpad but have not yet been activated. Use the following procedure to activate the
configuration commands in the scratchpad.
1. If you have not already done so, enter the enable command to enter Enable mode in
the CLI.
2. If you have not already done so, enter the configure command to enter Configure
mode in the CLI.
3. Enter the following command:
ctron-ssr-1# system show version
Software Information
Software Version : 1.0
Copyright : Copyright (c) 1996-1998 Cabletron Systems, Inc.
Image Information : Version 1.0.B.13, built on Wed Mar 25 22:49:07 1998
Image Boot Location: file:/pc-flash/boot/ssr8/
Boot Prom Version : prom-1.0
ctron-ssr-1# system promimage upgrade 10.50.11.12 prom2
Downloading image 'prom2' from host '10.50.11.12'
to local image prom2 (takes about 3 minutes)
kernel: 100%
Image checksum validated.
Image added.
save active