Filter
Top Products
SmartSwitch Router User Reference Manual 29
Chapter 1: SmartSwitch Router Product Overview
4. The CLI displays the following message:
5. Enter yes or y to activate the changes.
Note: If you exit Configure mode (by entering the exit command or pressing Ctrl+Z),
the CLI will ask you whether you want to make the changes in the scratchpad
active.
Copy the Configuration to the Startup Configuration File
After you save the configuration commands in the scratchpad, the Control Module
executes the commands and makes the corresponding configuration changes to the SSR.
However, if you power down or reboot the SSR, the new changes are lost. Use the
following procedure to save the changes into the Startup configuration file so that the SSR
reinstates the changes when you reboot the software.
1. Ensure that you are in the Enable mode by entering the enable command.
2. Enter the following command to copy the configuration changes in the Active
configuration to the Startup configuration:
3. When the CLI displays the following message, enter yes or y to save the changes.
Note: You also can save active changes to the Startup configuration file from within
Configure mode by entering the save startup command:
The new configuration changes are added to the Startup configuration file stored in the
Control Module’s boot flash.
Managing the SSR
The SSR contains numerous system facilities for system management. You can perform
configuration management tasks on the SSR including:
• Setting the SSR name
• Setting the SSR date and time
• Configuring the CLI
• Configuring SNMP services
Do you want to make the changes Active? [y]
copy active to startup
Are you sure you want to overwrite the Startup configuration? [n]