Filter
Top Products
SmartSwitch Router User Reference Manual 25
Chapter 1: SmartSwitch Router Product Overview
To exit Configure mode and return to Enable mode, use one of the following commands:
Boot PROM Mode
If your SSR does not find a valid system image on the external PCMCIA flash, the system
might enter programmable read-only memory (PROM) mode. You should then reboot the
SSR at the boot PROM to restart the system. If the system fails to reboot successfully,
please call Cabletron Systems Technical Support to resolve the problem.
To reboot the SSR from the ROM monitor mode, enter the following command.
Disabling a Function or Feature
The CLI provides for an implicit negate. This allows for the “disabling” of a feature or
function which has been “enabled”. Use the negate command on a specific line of the
active configuration to “disable” a feature or function which has been enabled. For
example, Spanning Tree Protocol is disabled by default. If after enabling Spanning Tree
Protocol on the SmartSwitch Router, you want to disable STP, you must specify the negate
command on the line of the active configuration containing the
stp enable
command.
Loading System Images and Configuration Files
The SSR contains an internal flash on the Control Module and an external PC flash. The
internal flash contains the SSR boot image and user defined configuration files. An
external PC flash contains the system image executed by the Control module. When an
tacacs - Configure TACACS related parameters
vlan - Configure VLAN-related parameters
Special configuration mode commands:
erase - Erase configuration information
negate - Negate a command or a group of commands
using line numbers
no - Negate matching commands
save - Save configuration information
search - Look up a command in configuration
show - Show configuration commands
Exit Configure mode.
exit
Ctrl+Z
Reboot in Boot PROM mode.
reboot