Filter
Top Products
Chapter 4 System Startup and Basic System Configuration
Cisco IOS User Interface
4-20
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
OL-11496-01
to configure each interface of the system.
Would you like to enter basic management setup? [yes/no]: Yes
Configuring global parameters:
Enter host name [Router]: Milo
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret [<Use current secret>]: barney
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: wilma
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: bambam
Configure SNMP Network Management? [no]:
Current interface summary
Interface IP-Address OK? Method Status Protocol
Ethernet0 unassigned YES unset administratively down down
POS1/0 unassigned YES unset administratively down down
SDCC1/0 unassigned YES unset administratively down down
POS2/0 unassigned YES unset administratively down down
SDCC1/0 unassigned YES unset administratively down down
.
.
.
POS15/0 unassigned YES unset administratively down down
SDCC15/0 unassigned YES unset administratively down down
Enter interface name used to connect to the
management network from the above interface summary: Ethernet0
Configuring interface Ethernet0:
Configure IP on this interface? Yes
IP address for this interface: 172.16.72.2
Subnet mask for this interface: 255.0.0.0
Class B network is 172.16.0.0, 8 subnet bits; mask is /24
The following configuration command script was created:
hostname Milo
enable secret 5 $1$krIg$emfYm/1OwHVspDuS8Gy0K1
enable password wilma