Filter
Top Products
4-61
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
OL-11496-01
Chapter 4 System Startup and Basic System Configuration
Using RP Flash Memory Cards
Step 2 Enter the dir command to further verify that the configuration file is copied
correctly to the memory card in slot 0:
Milo# dir slot0:
-#- -length- -----date/time------ name
1 5200084 May 10 1997 19:24:12 gsr-p-mz.112-8
3 1215 May 10 1997 20:30:52 myfile1
4 6176844 May 10 1997 23:04:10 gsr-p-mz.112-8.1
5 1186 May 10 1997 16:56:50 myfile2
9197156 bytes available (11381148 bytes used)
Milo#
Copying a Startup Configuration File from a Flash Memory Card to RP NVRAM
Enter the copy command in the following form to copy a startup configuration file
from a flash memory card to NVRA.M:
copy [slot0:|slot1:]filename startup-config
Where:
• [slot0: | slot1:] specifies the source of the configuration file to be copied.
• filename is the name of the configuration file to be copied.
• startup-config specifies the destination (NVRAM) of the file to be copied.
Milo# copy slot0:myfile startup-config
[ok]
Milo#
Copying a Configuration File from NVRAM to DRAM
Enter the following command to copy the startup configuration file from NVRAM
to DRAM to designate it as the default running configuration file for the system:
Milo# copy startup-config running-config
Milo#
%SYS-5-CONFIG_I: Configured from memory by console
Milo#