Filter
Top Products
4-63
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
OL-11496-01
Chapter 4 System Startup and Basic System Configuration
Post-Installation Procedures
Post-Installation Procedures
After you install the router hardware, check all external connections, turn on the
system power, allow the system to boot up, and minimally configure the system,
you may need to perform additional configuration tasks.
The Cisco IOS software running your router contains extensive features and
functionality. For information on Cisco IOS software and general installation and
maintenance information for your router, use the following resources:
• For Cisco IOS software configuration information and support, refer to the
modular configuration and modular command reference publications. You
can also refer to the Cisco IOS software release notes for the version of Cisco
IOS software you are using on your router.
Note To access Cisco IOS software documentation and hardware installation
and maintenance documentation, go to http://www.cisco.com.
• For information on regulatory compliance and safety, refer to the Regulatory
Compliance and Safety Information for Cisco 12000 Series Internet Routers
publication.
• For additional line card information, refer to the installation and
configuration note for your line card.
• For additional GRP information, refer to the configuration note Gigabit Route
Processor (GRP) Installation and Configuration Note.
• For additional PRP information, refer to the Performance Route Processor
(PRP) Installation and Configuration Note.