Filter
Top Products
Chapter 4 System Startup and Basic System Configuration
Configuring the Software Configuration Register
4-36
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
OL-11496-01
Step 3 Set the contents of the software configuration register by entering the
config-register value command, where value is a hexadecimal number preceded
by 0x.
Milo(config)# config-register 0xvalue
Note Consult the hexadecimal column in Table 4-4 on page 4-32 for the
possible settings to enter as the 4-bit value parameter.
Step 4 Press Ctrl-Z to exit global configuration mode.
Milo(config)# config-register 0xvalue
Milo(config)# Ctrl-Z
Milo#
Step 5 Enter the show version command to verify the software configuration register
value that is currently in effect, and the new value you entered (in Step 3) the next
time the router reloads.
Milo# show version
.
.
.
Configuration register is 0x141 (will be 0x102 at next reload)
Step 6 Enter the copy running-config startup-config command to save the software
configuration register settings to NVRAM.
Milo# copy running-config startup-config
Step 7 Reboot the system.
Note Configuration register changes take effect only after the system reboots
(for example, when you enter a reload command from the console).