Filter
Top Products
Chapter 4 System Startup and Basic System Configuration
Using RP Flash Memory Cards
4-56
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
OL-11496-01
Copying Cisco IOS Software Images Between Flash Memory Cards
This procedure describes how to copy a later Cisco IOS software image from one
flash memory card to another flash memory card containing an earlier Cisco IOS
software image. In this example, the following filenames apply:
• image.new—The new image on the flash memory card located in slot 1.
• image.old—The old image on the flash memory card in slot 0.
• image.boot—The bootable Cisco IOS software image stored in the onboard
flash memory SIMM. (This image is used by default to boot the system if no
other bootable image is available.)
This procedure assumes there is sufficient space on the flash memory card in
slot 0 for both images (the new Cisco IOS software image and the old image).
• If there is not enough space for both images on the card in slot 0, use the
delete command to delete unnecessary files from the flash memory card, but
do not delete the image.old file.
• After deleting the files, use the squeeze command to remove the deleted files
from the flash memory card in slot 0 permanently.
For additional information about the delete and squeeze commands, see the
“Flash Memory Commands” section on page 4-49).
Use the following procedure to copy a bootable Cisco IOS software image from
one flash memory card to another.
Step 1 Insert the flash memory card with the new image in slot 1.
Step 2 Enter the following command to copy the image.new file from the memory card
in slot 1 to the memory card in slot 0:
Milo# copy slot1:image.new slot0:image.new