Filter
Top Products
4-27
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
OL-11496-01
Chapter 4 System Startup and Basic System Configuration
Cisco IOS User Interface
System image file is "tftp://xxx.xxx.xxx.xxx/directory/ghall/gsr-p-mz"
cisco 12410/GRP (R5000) processor (revision 0x05) with 262144K bytes
of memory.
R5000 CPU at 200Mhz, Implementation 35, Rev 2.1, 512KB L2 Cache
Last reset from power-on
1 Route Processor Card
2 Clock Scheduler Cards
5 Switch Fabric Cards
2 OC48 POS controllers (2 POS).
1 four-port OC48 POS controller (1 POS).
1 Ethernet/IEEE 802.3 interface(s)
6 Packet over SONET network interface(s)
507K bytes of non-volatile configuration memory.
8192K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x0
...
Using Global Configuration Mode
Global configuration mode enables you to enter configuration commands
line–by–line from the console terminal. If you prefer not to use the interactive
script of the setup facility, you can manually configure your router using global
configuration mode.
To display a list of the configuration commands available to you, enter a question
mark (?) at any prompt or press the designated help key on the terminal keyboard
while in configuration mode.
Use the following procedure to configure your router using global configuration
mode.
Step 1 When you are prompted to enter the system configuration dialog at bootup,
answer no.
Would you like to enter the initial dialog? [yes]: no
Milo>
Step 2 Enter the enable command and password (if prompted).
Milo> enable
Password: <password>
Milo#