Filter
Top Products
4-45
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
OL-11496-01
Chapter 4 System Startup and Basic System Configuration
Using RP Flash Memory Cards
Step 3 Insert the card into the appropriate slot until the card completely seats in the
connector and the ejector button pops out (see Figure 4-5b).
Caution The flash memory card is keyed for proper insertion. The ejector button does not
pop out unless the card is inserted correctly. Part of the card remains outside of
the slot even when the card is properly seated. Do not attempt to force the card
deeper into the slot after the ejector button pops out.
Step 4 Replace the flash memory card slot cover.
Use the following procedure to remove a flash memory card.
Step 1 Remove the flash memory slot cover by loosening its captive screw (illustration
is shown without the cover for clarity).
Step 2 Press the appropriate ejector button to eject the card from the connector at the
back of the slot (see Figure 4-5c).
Step 3 Pull the card from the slot and place it in an antistatic bag to protect it from ESD
damage.
Step 4 Replace the flash memory card slot cover.