Filter
Top Products
Crestron TPMC-4XG-B Isys i/O™ Handheld WiFi Touchpanel
Industry Compliance
As of the date of manufacture, the TPMC-4XG-B has been tested and found to
comply with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling.
NOTICE: FCC NOTICE: This equipment has been tested and found to comply
with the limits for a class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy if not installed and used in accordance with the
instructions and may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions: (1) this device may not cause
harmful interference and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been verified to comply with the limits for a class B computing
device, pursuant to FCC Rules. In order to maintain compliance with FCC
regulations, shielded cables must be used with this equipment. Operation with non-
approved equipment or unshielded cables is likely to result in interference to radio
and TV reception.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. In order to avoid the possibility of exceeding the FCC
radio frequency exposure limits, human’s body proximity to the device should not be
less than 20 cm during normal operation.
WARNING: Changes or modifications of this equipment not expressly approved by
the party responsible for compliance could void the user’s authority to operate the
equipment.
FCC ID: MG372400C
IC ID: 2575A-URC7240C
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN
INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
The socket-outlet shall be installed near the equipment and shall be easily accessible.
The equipment is to be supplied from an identified USB port complying with the requirements
of Limited Power Source.
Corporate Headquarters
Universal Electronics
6101 Gateway Drive
Cypress, CA 90630-4841
714-820-1000
www.uei.com
Operations Guide – DOC. 6749A Isys i/O™ Handheld WiFi Touchpanel: TPMC-4XG-B • 11