Filter
Top Products
10- ENG
D23766
6. If the handle has excessive
movement, it is improperly
installed. Check the following.
A. Are both tabs inside the
handle (Step #3)?
B. Does each clip pass through
both the saddle and handle
(Step #4)?
Assemble Rubber Strip
(if equipped)
1. Remove the protective paper
strip from the adhesive-backed
rubber foot strip. Attach the
rubber foot strip to the bottom of
the air tank leg. Press firmly into
place.
Assemble Rubber Feet
(if equipped)
1. Attach rubber feet with the
screws, washers and nuts
provided as shown.
2. Tighten securely.
Screw
Nut
Flat
Washer
Rubber Foot
Rubber
Foot Strip
Tank Leg
To Assemble Wheels
It will be necessary
to brace or support
one side of the unit when installing
the wheels because the
compressor will have a tendency to
tip.
1. Attach wheels with shoulder
bolts and nuts as shown.
2. Tighten securely. NOTE: The unit
will sit level if the wheels are
properly installed.
The wheels and
handle do not
provide adequate clearance,
stability or support for pulling the
unit up and down stairs or steps.
The unit must be lifted, or pushed
up a ramp.
Wheel
Shoulder Bolt
Nut
To Add Oil To Pump
Compressors are
shipped without
oil. A small amount of oil may be
present in the pump upon receipt
of the air compressor. This is due
to plant testing and does not mean
the pump contains oil. Do not
attempt to operate this air
compressor without first adding oil
to the crankcase. Serious damage
can result from even limited
operation unless filled with oil and
broken in correctly. Make sure to
closely follow initial start-up
procedures.