Filter
Top Products
23- ENG
D23766
c. Using an adjustable wrench,
rotate the pressure switch
assembly as shown.
d. It is now possible to remove
regulator.
6. Apply pipe sealant tape to the
nipple.
7. Assemble the regulator and
orient as shown in figure.
NOTE: Arrow indicates flow of air.
Make sure it is pointing in the
direction of air flow.
8. Reapply pipe sealant to outlet
pressure gauge, tank pressure
gauge, and quick connect.
9. Reassemble outlet pressure
gauge, tank pressure gauge, and
quick connect. Orient outlet
pressure gauge and tank
pressure gauge to read correctly.
Tighten quick connect with
wrench.
10. If necessary, rotate pressure
switch assembly into correct
position.
11. If necessary, tighten pressure
relief tube nuts at air tank and
pressure switch.
12. If necessary, replace handle.
Refer to Handle Assembly
paragraph in the Assembly
section.
13. Replace console cover and
regulator ring.
To Replace Belt
Serious injury or
damage may occur
if parts of the body or loose items
get caught in moving parts. Never
operate the unit with the belt guard
removed. The belt guard should be
removed only when the
compressor is unplugged.
1. Place the ON/AUTO-OFF lever in
the "OFF" position.
2. Unplug compressor.
3. Remove the front of the belt
guard by disengaging the snaps.
Insert a flat bladed screwdriver at
each snap location and pry the
beltguard apart.
4. Loosen the wing nut on hold
down plate and tilt motor to
allow for easy removal or
installation of the belt.
5. Remove belt.
6. Replace belt. NOTE: The belt
must be centered over the
grooves on the flywheel and
motor pulley.
7. Turn the wing nut on the hold
down plate until it makes contact
with the washer, plus one
additional turn.
8. Replace the belt guard.
Wing Nut
Arrow
Regulator