Filter
Top Products
Vigor2900 Series User’s Guide
114
Enable Check this box to enable this function (for VLAN
Configuration).
P1 – P4 Check the box to make the computer connecting to the port
being grouped in specified VLAN. Be aware that each port can
be grouped in different VLAN at the same time only if you
check the box. For example, if you check the boxes of
VLAN0-P1 and VLAN1-P1, you can make P1 to be grouped
under VLAN0 and VLAN1 simultaneously.
VLAN0-3 This router allows you to set 4 groups of virtual LAN.
Enable(for Rate Control) Check this box to enable this function (for Rate Control). The
rate control will limit the transmission rate for data in and out.
Check the corresponding boxes to enable the rate control
function for different ports.
Out It decides the rate of data transmission for output. When you
check the box of Enable, please also decide the rate by using
the drop down list of Rate.
In It decides the rate of data transmission for input. When you
check the box of Enable, please also decide the rate by using
the drop down list of Rate.
To add or remove a VLAN, please refer to the following example.
1. If, VLAN 0 is consisted of hosts linked to P1 and P2 and VLAN 1 is consisted of hosts
linked to P3 and P4.
2. After checking the box to enable VLAN function, you will check the table according to
the needs as shown below.