Filter
Top Products
Vigor2900 Series User’s Guide
34
applicable if you select WPA/PSK.
WEP/802.1x or WPA/802.1x - Accept WEP or WPA
clients with 802.1x authentication. Only
Mixed(WPA+WPA2) is applicable if you select WPA/PSK.
Since the key will be auto-negotiated during authentication,
the field of key setting below will be not available for input.
WPA/PSK Only - Accepts WPA clients and the
encryption key should be entered in PSK. Remember to
select WPA type to define either Mixed or WPA2 only in
the field below.
WPA/802.1x Only - Accept WPA clients with 802.1x
authentication. Remember to select WPA type to define
either Mixed or WPA2 only in the field below. Since the
key will be auto-negotiated during authentication, the field
of key setting below will be not available for input.
Radius Server If you select WEP/802.1x Only, WEP/802.1x or
WPA/802.1x or WPA/802.1x Only as the security mode,
you have to set up RADIUS Server for using with those
modes. Click the Radius Server link to open the following
page.
Check Enable. Type the IP address for the Radius server.
Specify the destination port. The default setting is 1812.
Then type the shared secret and confirm the key again.
When you finish the settings, please click OK to leave the
page and invoke the settings.
WPA The WPA encrypts each frame transmitted from the radio
using the key, which either PSK entered manually in this
field below or automatically negotiated via 802.1x
authentication.
Pre-Shared Key (PSK) - Enter 8~63 ASCII characters,
such as 012345678.(or 64 Hexadecimal digits leading by
0x, such as "0x321253abcde...").
WEP 64-Bit - For 64 bits WEP key, enter 5 ASCII characters,
such as 12345 (or 10 hexadecimal digitals leading by 0x,
such as 0x4142434445.)
128-Bit -
For 128 bits WEP key, enter 13 ASCII characters,
such as ABCDEFGHIJKLM (or 26 hexadecimal digits
leading by 0x, such as
0x4142434445464748494A4B4C4D).