Filter
Top Products
Vigor2900 Series User’s Guide
140
8. Set Dial-In settings as shown below to allow Router B dial-in to build VPN connection.
If an IPSec-based service is selected, you may further specify the remote peer IP
Address, IKE Authentication Method and IPSec Security Method for this Dial-In
connection. Otherwise, it will apply the settings defined in IPSec General Setup above.
If a PPP-based service is selected, you should further specify the remote peer IP Address,
Username, Password, and VJ Compression for this Dial-In connection.
9. At last, set the remote network IP/subnet in TCP/IP Network Settings so that Router A
can direct the packets destined to the remote network to Router B via the VPN
connection.