Filter
Top Products
Page 30
iQ Series, Ultrasonic Hand Held Systems User’s Manual
Dukane Manual Part No. 403-577-01
Setup Maintenance
Introduction
The screens available in Setup Maintenance allow the
operator to Load, Store, or Delete generator weld setups.
As many as eight (8) setups can be loaded and stored for
your convenience.
Navigating
1. When the SETUP key is pressed for the rst time, the
display looks like Figure 5-18. This screen indicates
that Setup #1 is Empty. Because there is not yet any
data available, this setup has nothing in it, and is
empty. You will see that Load is highlighted.
Press ENTER.
2. Load - (Load means to put data into the generator’s
memory, or to program a setup.)
A pop-up screen asks if defaults should be loaded for
Setup #1. See Figure 5-18A.
Select NO, and the display will change to an Operate
screen.
Select YES, and Manual Weld shows at the top of
the Operate screen that will display next. The setup
number appears in the lower left corner of the screen.
Refer to Figure 4-4.
3. After selecting YES, press SETUP, and the display
will look like Figure 5-19.
4. Store - (Store means to save the setup data.)
Tap the right arrow key once to highlight Store.
See Figure 5-20.
5. Press ENTER, and a pop-up screen as shown in
Figure 5-21 appears.
6. Select YES if you want to overwrite (replace)
whatever is in the setup, and select NO if you do not
want to change anything for that setup.
Press the ENTER key to save your selection.
7. Delete -To delete the setup, select Delete as shown
in Figure 5-22, and press the ENTER key. A pop-up
screen appears to ask you to conrm your choice.
Select YES or NO, and press ENTER again.
Setup Maintenance
Load
Store
Setup # 1
EMPTY
Delete
Figure 5-18 Setup Maintenance - 1
Setup Maintenance
Load
Store
Setup # 1
T: 0.000 S A: 100%
Mode: Manual
E: 0 J H: 0.0 S
Delete
Figure 5-19 Setup Maintenance - 2
Setup Maintenance
Load
Store
Setup # 1
T: 0.000 S A: 100%
Mode: Manual
E: 0 J H: 0.0 S
Delete
Figure 5-20 Setup Maintenance - 3
Figure 5-21 Pop-up Overwrite Setup?
Setup Maintenance
Delete
Store
Setup # 1
T: 0.000 S A: 100%
Mode: Manual
E: 0 J H: 0.0 S
Load
Figure 5-22 Setup Maintenance - 4
NO
Overwrite
Setup #1?
YES
NO
Setup #1 Empty
Load Defaults?
YES
Figure 5-18A Pop-up Load Defaults?
Continued