Dukane iQ Series Welding System User Manual


 
Page  31
Section 5 - Process Control Settings
Dukane Manual Part No. 403-577-01
Setup Maintenance Continued
Saving the Current Setup
Try using your navigation skills on this example:
1. Follow instructions on Page 24 to set the mode to
Weld by Time. Set the time to 1.520 seconds.
See Figure 5-23.
2. Press SETUP and then press the
+
key until you
get an Empty Setup Maintenance screen.
See Figure 5-24.
3. Use the right arrow key to select Store, and then
press ENTER. You will be returned to the Operate
screen.
4. Conrm that your setup has been stored in memory
by going back to SETUP. Your new setup should
appear, just as it does in Figure 5-25.
Selecting a Setup
To select a setup previously stored:
1. Press SETUP.
2. With Load highlighted, use the keys to select
the number of the setup you want.
3. Press ENTER.
4. The Operate screen will display this selection as a
number in the lower left hand corner.
Deleting a Setup
To delete a setup previously stored:
1. Press SETUP.
2. With Delete highlighted, use the keys to select
the number of the setup you want.
3. Press ENTER, and a pop-up screen will ask you to
conrm your selection. Make your choice, and press
ENTER.
4. Check that the setup is deleted. Press SETUP, and the
Setup Maintenance screen will show EMPTY for the
setup you just deleted.
Figure 5-23 Save Current Setup
Figure 5-24 Store in Setup Maintenance
Figure 5-25 New Setup Stored
Setup Maintenance
Load
Store
Setup # 1
T: 1.520 S A: 100%
Mode: Manual
E: 0 J H: 0.0 S
Delete
Weld by Time
Press Enter To Accept
Press Cancel To Abort
Weld Time
1.520 S
Setup Maintenance
Load
Store
Setup # 1
EMPTY
Delete
+ -
+ -