Filter
Top Products
Appendix A
70 312359J
Run (Fluid Control) Screens
Run (fluid control) is the first screen displayed at power
on. It enables users to spray material, and operate and
park pumps. Run consists of two screens: power
on/enter and ratio mode.
The power on/enter screen cycles through power on
mode, spray mode, and pump mode. It always displays
the current ratio setpoint, and may also display: pres-
sure, temperature and flow rate if these functions are
selected.
The ratio screen displays the current ratio and monitors
the B side restriction adjustment.
Power On/Enter Mode
Power On/Enter Mode is the default screen when users
enter Fluid Control.
NOTE:
This screen remains blank until a mode is selected.
Spray Mode
Users must be in this mode to spray or proportion mate-
rial. Press the button below the spray icon to enter this
mode.
Pump Mode
Users must be in this mode to operate pumps for prim-
ing or flushing. Press the button below the pump icon to
enter this mode. Continue pressing the pump icon but-
ton to cycle through pump A, pump B, and both pumps.
Icon Function
Spray: proportion and spray material.
Run pumps: operate both pumps or oper-
ate each pump independent from the other
(priming, flushing).
Park Pumps: runs pump to bottom of the
stroke.
Ratio: jump to ratio screen.