Grizzly G0451 Saw User Manual


 
-26-
G0451 14" Sliding Table Saw
Crosscut Table
Figure 34. Installing the crosscut table.
Components and Hardware Needed: Qty
Crosscut Table ...................................................
1
Crosscut Table Brace .........................................
1
T-Nut M8-1.25 .....................................................
2
T-Nut M12-1.75 ....................................................
1
Flat Washer 12mm .............................................
1
Adjustable Handle M12-1.75 x 55 .......................
1
Knob M8-1.25 x 50 .............................................
2
Flat Washer 8mm ...............................................
2
Tools Needed: Qty
An Assistant .......................................................
1
To install the crosscut table:
1. Thread the M12-1.75 x 55 adjustable handle,
with a 12mm flat washer, through the cross
-
cut table and into a M12-1.75 T-nut as shown
in Figure 33.
2. With the help of an assistant, place the cross-
cut table on the pivot pin of the swing arm
and slide the T-nut into the T-slot in the slid
-
ing table (see
Figure 34).
Figure 33. Installing the adjustable handle.
3. Slide two M8-1.25 T-nuts into the crosscut
table brace.
4. Align the T-nuts in the crosscut table brace
with the holes in the crosscut table and
thread the M8-1.25 x 50 knobs, with 8mm flat
washers, into the T-nuts as shown in
Figure
35
.
Crosscut
Table Brace
Figure 35. Installing the crosscut table brace.