Filter
Top Products
G0451 14" Sliding Table Saw
-29-
Figure 42. Sliding table push handle.
Push
Handle
5. Slide the M12-1.75 T-nut into the sliding table
and thread in the M12-1.75 x 12 push handle
with a washer as shown in
Figure 42.
6. Slide the edge shoe into the table as shown
in Figure 43 when needed.
Figure 43. Edge shoe and hold down placement.
7. Slide the hold down onto the table when
needed and lock it in place as shown in
Figure 43.
Main Blade
The Model G0451 is designed to accommodate
either a 12" or a 14" main blade. But any time
you change blade sizes, the riving knife must be
adjusted to match the size of blade you install.
Components and Hardware Needed: Qty
Blade 12" or 14" (Not Included) .........................
1
Flat Belt 15 x 915mm .........................................
1
Riving Knife ........................................................
1
Tools Needed:
Arbor Wrenches .................................................
2
To install the blade:
1. Open the motor compartment and remove
the red shipping brackets from both motors.
2. Place the flat belt on the scoring blade arbor
as shown in
Figure 44, lift the scoring motor,
and slide the flat belt over the scoring motor
pulley.
Edge
Shoe
Hold
Down
Flat
Belt
Figure 44. Flat belt installation.
Scoring
Blade
Arbor
Scoring
Motor
3. Move the blade tilt to 0˚ and raise the main
blade as far as it will go.