Filter
Top Products
G0451 14" Sliding Table Saw
-41-
Crosscutting full size panels:
1. Install the crosscut fence in the forward
mounting points shown in
Figure 71 and lock
it in place.
2. Check to make sure the fence is at 90˚ and
adjust it as described in "Squaring Crosscut
Fence to Blade"
on Page 52 if necessary.
Figure 71. Crosscut fence mounting points.
3. Set either flip stop to the desired width-of-cut.
Note—Extend the crosscut fence slide if the
workpiece is more than 74".
4. Load the workpiece onto the table saw. The
set up should look similar to
Figure 68.
5. Once all the necessary safety precautions
have been taken, perform the cutting opera
-
tion.
Crosscutting smaller panels:
1. Install the crosscut fence in the rear mount-
ing points shown in
Figure 71 and lock it in
place.
2. Check to make sure the fence is at 90˚ and
adjust it as described in "Squaring Crosscut
Fence to Blade"
on Page 52 if necessary.
3. Set either flip stop to the desired width-of-cut.
Note—Extend the crosscut fence slide if the
workpiece is more than 74".
Forward
Mounting Points
4. Load the workpiece onto the table saw. The
set up should look similar to
Figure 69.
5. Once all the necessary safety precautions
have been taken, perform the cutting opera
-
tion.
Crosscutting using the rip fence as a cut-off
gauge:
1. Install the crosscut fence in the rear mount-
ing points shown in
Figure 71 and lock it in
place.
2. Check to make sure the fence is at 90˚ and
adjust it as described in "Squaring Crosscut
Fence to Blade"
on Page 52 if necessary.
3. Position the rip fence for the desired width.
4. Load the workpiece onto the table saw. The
set up should look similar to
Figure 70.
5. Slide the leading end of the rip fence behind
the back edge of the blade as shown in
Figure 72.
Rear Mounting
Points
Figure 72. Correct rip fence position when using
it as a cut-off gauge.
6. Take all the necessary safety precautions,
then perform the cutting operation.