Grizzly G0451 Saw User Manual


 
G0451 14" Sliding Table Saw
-31-
Figure 50. Fence used to align blades.
To align the scoring blade set:
1. Move the blade tilt to 0˚ (blade 90˚ to table),
raise the main blade all the way up, and
use
the vertical adjustment knob (
Figure 49) to
raise the scoring blade to its highest point.
Aligning Scoring
Blade Set
3. Use the horizontal adjustment controls to
adjust the scoring blade until the rip fence
can touch both blades.
Scale Alignment
Before operation, align the rip fence scale with
the blade to ensure accurate measurements.
Tools Needed: QTY
Hex Wrench 3mm ...............................................
1
Hex Wrench 8mm ...............................................
1
To align the fence scale with the blade:
1. Tilt the blade to 0˚, raise the main blade all
the way up, and move the rip fence against
the blade as shown in
Figure 50.
2. Loosen the screws securing the scale, line up
the first mark on the scale with the left edge
of the rip fence, then tighten the screws.
3. Set the rip fence to
1
8", slide the adjustable
ring against the fence, and secure the ring to
prevent the fence from contacting the blade.
Scoring
Blade Vertical
Adjustment
Scoring Blade
Horizontal
Adjustment
2. Move the rip fence against the main blade (or
scoring blade) as shown in
Figure 50.
Figure 49. Scoring blade adjustment controls.
The kerf of the tapered scoring blade included
with this sliding table saw is adjusted by changing
the height of the scoring blade. See Page 37 for
replacement scoring blade adjusting instructions.
To change the scoring blade kerf:
1. Measure the main blade kerf, then measure
the scoring blade kerf at the table level.
2. Raise or lower the scoring blade until the kerf
matches the kerf of the main blade.
3. Perform a test cut and check for chip out on
the underside of the test piece. If there is
chip out, make the adjustments necessary to
match the kerfs.
Adjusting Scoring
Blade Kerf