Filter
Top Products
-40-
G0451 14" Sliding Table Saw
Figure 70. Crosscutting workpieces
using the rip fence as a cut-off gauge.
Lastly, this machine has the capability of cross
-
cutting workpieces while using the rip fence as a
cut-off gauge (Figure 70).
Determine which cutting operation will be best
suited for the workpiece to be crosscut.
— If you will be crosscutting full size panels,
then skip ahead to “Crosscutting full size
panels.”
— If you will be crosscutting smaller panels,
then skip ahead to “Crosscutting smaller
panels.”
— If you will be crosscutting workpieces using
the rip fence as a cut-off gauge, then skip
ahead to “Crosscutting using the rip fence
as a cut-off gauge.”
Figure 69. Crosscutting smaller panels.
Figure 68. Crosscutting full size panel.
The Model G0451 can crosscut full size panels
with the fence in the forward or rear position,
although it is easier to load full size panels with
the crosscut fence mounted in the forward posi
-
tion (see Figure 68).
Mounting the crosscut fence in the rear position
(Figure 69) gives greater stability for crosscutting
smaller panels.
Crosscutting
Forward Mounted
Crosscut Fence
Rear Mounted
Crosscut Fence