Filter
Top Products
-32-
G0451 14" Sliding Table Saw
Dust Collection
The Model G0451 is equipped with two dust ports
that should be properly connected to a dust col
-
lection system before operation.
Components and Hardware Needed: Qty
Blade Guard/Dust Hood .....................................
1
Flat Washer 8mm ...............................................
1
Button Head Screw M8-1.25 x 40 ......................
1
Dust Collection System ......................................
1
5" Dust Hose (length as needed) .......................
1
5" Hose Clamp ...................................................
2
2½" Dust Hose (length as needed) ....................
1
2½" Hose Clamp ................................................
2
Tools Needed:
Hex Wrench 6mm ...............................................1
Phillips Head Screwdriver ..................................
1
To connect the dust ports to a dust collection
system:
1. Secure a 5" dust hose to the dust port locat-
ed under the saw table (
Figure 51).
Figure 51. 5" dust port location.
Figure 52. 2" dust port location.
2. Run the 5" hose to your dust collection sys-
tem.
4. Secure a 2½" dust hose to the dust port
on the top of the blade guard as shown in
Figure 52.
5. Run the 2½" hose over the hose support
(Figure 53) and connect it to the dust collec-
tion system.
3. Slide the blade guard/dust hood over the riv-
ing knife and attach it with an M8-1.25 x 40
button head cap screw and a flat washer as
shown in
Figure 52.
6. Run a ground wire through the dust hose
and attach the wire to the machine to pro
-
tect against static electricity.
Figure 53. Dust hose support in use.