Filter
Top Products
G0451 14" Sliding Table Saw
-27-
Crosscut Fence
Components and Hardware Needed: Qty
Crosscut Fence ..................................................
1
Center Stud M8-1.25 x 10 ..................................
1
Fiber Washer 8mm .............................................
1
T-Nut M8-1.25 .....................................................
1
Knob M8-1.25 x 25 .............................................
1
Knob M8-1.25 .....................................................
1
T-Bolt M8-1.25 x 60 ............................................
1
Flat Washer 8mm ...............................................
1
Tools Needed: Qty
Hex Wrench 6mm ...............................................
1
To install the crosscut fence:
1. Thread the center stud and the fiber washer
into the remaining M8-1.25 T-nut.
2. Slide the center stud, an M8-1.25 x 60 T-
bolt, and screw a M8-1.25 x 25 knob into the
crosscut fence as shown in
Figure 36.
Figure 36. Crosscut fence assembly.
Center Stud T-Bolt
Knob
3. Slide the center stud to the end with the plas-
tic cap and tighten it in place.
4. Insert the center stud and the T-bolt in the
places indicated in
Figure 37.
Figure 37. Crosscut fence placement.
Center Stud
Placement
T-Bolt
Placement
5. Secure the crosscut fence with the M8-1.25
knob with an 8mm flat washer threaded onto
the T-bolt.
6. Unlock the crosscut fence extension and
slide the flip stops into the fence as shown in
Figure 38.
Figure 38. Stop block installation.