Grizzly G0451 Saw User Manual


 
-36-
G0451 14" Sliding Table Saw
Riving Knife
Adjustment
6. Position the riving knife about 3mm or
1
8"
away from the nearest carbide tooth on the
main blade. Note—For a quick gauge, use
the 3mm hex wrench to find the correct spac
-
ing between the blade and the riving knife, as
shown in
Figure 58.
7. Tighten the center bolt to secure the riving
knife in position.
8. Move the blade guard back to its original
position, and move the sliding table back to
center.
Figure 58. Aligning the riving knife.
Figure 57. Re-adjusting the riving knife.
Riving Knife
Whenever the blade size is changed (12" or 14"
blade), the riving knife must be adjusted to 3mm
away from the blade you install.
To adjust the riving knife:
1. Disconnect the saw from the power
source!
2. Move the blade tilt to 0˚ (blade 90˚ to table),
and raise the main blade as far as it will go.
3. Move the sliding table all the way forward to
expose the internal blade guard that covers
the blades and riving knife.
4. Pull the blade guard away from the riving
knife to expose the mounting assembly.
(The internal blade guard is held in place
with a magnet.)
5. Loosen the riving knife center bolt, slide the
riving knife away from the blade as shown in
Figure 57, and slightly tighten.