Filter
Top Products
Model G0795 (Mfd. Since 02/15)
-17-
HEADSTOCK MUST
BE FILLED WITH OIL!
OIL MAY NOT BE
SHIPPED WITH MACHINE!
Refer to Lubrication Section
for Correct Oil Type.
Lubricating Mill /Drill Te s t Ru n
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning properly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting
table in the
SERVICE section of this manual can help.
The test run consists of the following: 1) the motor
powers up and runs correctly, 2) the E-Stop button
safety feature works correctly, and 3) the tapping
controls work correctly.
To test run mill/drill:
1. Clear all setup tools away from machine.
2. Press E-Stop button (see Figure 12). This
will help prevent unexpected startup when
machine is connected to power.
3. Connect machine to power supply, and press
Power button (see Figure 12). Power indica-
tor light should turn ON.
The headstock oil reservoir must have the proper
amount of oil in it before the mill/drill can be oper-
ated for the first time.
Damage caused by running the mill/drill without
oil in the reservoir will not be covered under war-
ranty. Refer to the Lubrication subsection, begin-
ning on Page 34, for details on how to check and
add oil.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
Figure 12. Location of power indicator light and
E-Stop button.
4. Rotate mode switch to "Drill".
Power
Indicator
Light
E-Stop
Button