Filter
Top Products
Model G0795 (Mfd. Since 02/15)
-25-
Removing Tooling
Tools Needed Qty
Wrench 16mm ................................................... 1
Spindle Wrench ................................................. 1
Brass Head or Dead Blow Hammer .................. 1
To remove tooling:
1. DISCONNECT MACHINE FROM POWER!
2. Remove drawbar cap.
3. Place spindle wrench over spindle flats to
keep the spindle from rotating, and use
16mm wrench to loosen drawbar one full
rotation.
Note: Do not fully unthread tooling from
drawbar or the drawbar and tool threads
could be damaged in the next step.
4. Tap top of drawbar with hammer to unseat
taper.
5. Hold onto tooling with one hand and fully
unthread drawbar with the other hand.
3. Install drawbar (see Figure 4 on Page 12).
4. Position tool alignment slot (see Page 24)
with pin inside spindle, then insert tooling into
spindle until it contacts drawbar.
5. Working from top end, thread drawbar by
hand into tooling until snug.
6. Place 16mm wrench over drawbar, then use
spindle wrench on spindle flats (see Figure
23) to keep spindle from rotating.
Do not overtighten drawbar. Overtightening
makes tool removal difficult and may dam-
age arbor and threads.
Figure 23. Location of spindle flats and drawbar.
Drawbar
Spindle
Flats
7. Tighten drawbar and re-install drawbar cap.