Filter
Top Products
-36-
Model G0795 (Mfd. Since 02/15)
Quill Outside Surface
Lube Type ...Model T23962 or ISO 68 Equivalent
Lube Amount ........................................Thin Coat
Lubrication Frequency ........... 8 hrs. of Operation
Without disturbing the grease on the quill rack,
clean the outside smooth surface of the quill (see
Figure 52) with mineral spirits and shop rags.
Figure 52. Outside surface of quill.
Quill Outside
Surface
When dry, apply a thin coat of lubricant to the
smooth surface, then move the spindle up and
down to evenly distribute the oil.
Table Leadscrews
Lube Type ..............NLGI#2 or ISO 68 Equivalent
Lube Amount ........................................Thin Coat
Lubrication Frequency ......... 40 hrs. of Operation
Tool Needed Qty
Hex Wrench 5mm .............................................. 1
Move the table as necessary to access the entire
length of the X- and Y-axis leadscrews (see
Figures 53–54). Remove the way cover from the
base to access the Y-axis leadscrew. Use mineral
spirits, shop rags, and a brush to clean them.
When dry, use a clean brush to apply a thin coat
of oil to the leadscrew threads, then move the
table through the X- and Y-axis paths to distribute
the oil.
Figure 53. Location of X-axis leadscrew.
X-Axis Leadscrew
Figure 54. Location of Y-axis leadscrew.
Y-Axis Leadscrew