Filter
Top Products
Model G0795 (Mfd. Since 02/15)
-23-
Controlling Table
Travel
The table travels in two directions and is con-
trolled by handwheels, as illustrated in Figure 19:
• X-axis (longitudinal)
• Y-axis (cross)
Both the X- and Y-axis feature table locks. To
ensure unexpected movement of the table does
not occur during precision operations, use these
locks to secure the table along any axis that
should not move for any given operation.
X-Axis or Longitudinal Travel
(Left & Right)
Y-Axis or
Cross Travel
(In & Out)
Figure 19. Directions of table movement.
The table handwheels have graduated dials in
0.001" increments, with one full revolution equal-
ling 0.10". These dials provide an easy way to
gauge precise table movements while milling.
Figure 20. Graduated dial on table handwheel.
Graduated Dial
Tilting Headstock
1. DISCONNECT MACHINE FROM POWER!
2. Loosen the three hex nuts (see Figures
17–18) that lock headstock tilt in position.
3. Using tilt scale shown in Figure 17 as a
guide, push or pull headstock to swivel it into
desired position, then retighten the three hex
nuts to secure it.
Figure 17. Hex nut (one on each side of
headstock).
Tilt
Scale
Figure 18. Hex nut underneath headstock
(headstock tilted 90° for clarity).
Hex Nut
(1 of 3)
Hex Nut
(1 of 3)