Filter
Top Products
-20-
Model G0795 (Mfd. Since 02/15)
SECTION 4: OPERATIONS
To complete a typical operation, the operator
does the following:
1. Examines workpiece to make sure it is suit-
able for milling and drilling.
2. Securely clamps workpiece to table.
3. With machine disconnected from power,
installs correct cutting tool.
4. Adjusts headstock height above table.
5. Selects correct spindle speed and gear set-
ting on gearbox.
6. Connects machine to power and turns it ON.
7. Puts on required safety glasses and face
shield.
8. Uses downfeed controls or table controls to
perform cutting operation.
9. Turns machine OFF and waits for spindle to
completely stop before removing workpiece,
changing tooling, or changing spindle speeds.
10. Disconnects machine from power.
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the
machine controls/components
discussed later
in this manual
are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual and
seek additional training from expe
-
rienced
machine operators, and do additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
To reduce risk of eye or face injury from
flying chips, always wear approved safety
glasses and a face shield when operating
this machine.
Eye injury hazard! Always
wear safety glasses when
using this machine.