Filter
Top Products
Model G0795 (Mfd. Since 02/15)
-41-
Tightening Return
Spring Tension
The return spring moves the spindle back up
when the coarse downfeed handles are released.
The tension of this spring was adjusted at the fac-
tory, but it may need to be tightened during the life
of the mill/drill.
Important: Do not perform this procedure unless
it is absolutely necessary. The high amount of
spring tension involved can make this a difficult
procedure. Return spring tension is adjusted at
the factory and should be suitable for most appli-
cations.
To adjust the return spring tension:
1. DISCONNECT MACHINE FROM POWER!
2. Wipe off any oil on spring cover so it does not
slip when you hold it during adjustments.
3. Mark slot on cover that engages roll pin—this
is the factory setting.
4. Put on heavy leather gloves to protect your
hands from lacerations if spring uncoils dur-
ing next step.
Note: Keep a good grip on spring cover dur-
ing next step. Letting go of cover when roll
pin is not engaged will cause spring to rapidly
uncoil.
5. While holding spring cover against side of
headstock so spring will not unwind, loosen
thumb screw approximately
1
⁄4".
6. Pull cover out just enough to disengage it with
roll pin, then rotate it clockwise to engage roll
pin in next slot in cover.
7. Retighten thumb screw to secure setting.
If the return spring should
come loose from the spring
cap and rapidly unwind,
laceration or impact inju-
ries could occur. Always
wear heavy leather gloves
and safety glasses when
adjusting the return spring
tension.
Eye injury hazard! Always
wear safety glasses when
using this machine.
Figure 59. Return spring components.
Thumb
Screw
Cover
Slot
Cover
Roll
Pin
During this procedure, you will loosen the spring
cover thumb screw (see Figure 59) just enough
to pull the cover back to clear the roll pin, then
rotate the cover clockwise to fit the roll pin in the
next slot.