Filter
Top Products
-24-
Model G0795 (Mfd. Since 02/15)
Installing /Removing
To o l i ng
The Model G0795 includes a 3–16mm drill chuck
with an R-8 arbor (see Figure 22). The R-8 arbor
is precision-ground, and features a tool slot for
easy, secure alignment in the mill/drill spindle.
The tapered R-8 arbor end joins securely with the
drill chuck to support tooling from 3–16mm.
Cutting tools are sharp and
can easily cause laceration
injuries. Always protect
your hands with leather
gloves or shop rags when
handling cutting tools.
Tool Slot
Figure 22. Drill chuck joined with R-8 arbor.
R-8 Arbor
Drill
Chuck
Installing Tooling
Tools Needed Qty
Wrench 16mm ................................................... 1
Spindle Wrench.................................................. .... 1
To install tooling:
1. DISCONNECT MACHINE FROM POWER!
2. Remove drawbar cap, as shown in Figure 23.
This machine is equipped with adjustable limit
stops on each end of the table and a stop block
in the center. The limit stops can be secured any-
where along the table so they make contact with
the stop block to limit table travel along the X-axis.
This feature is typically used when milling up to a
shoulder.
Figure 21. Limit stops and stop block for limiting
table movement.
Limit Stops
Stop
Block