Filter
Top Products
-18-
Model G0795 (Mfd. Since 02/15)
11. Without resetting E-Stop button, press "Left"
button. Machine should not start.
—If machine does start (with E-Stop button
pushed in), immediately disconnect power
to machine. E-Stop safety feature is not
working correctly. This safety feature must
work properly before proceeding with regu-
lar operations. Refer to Troubleshooting
on Page 38 for help.
12. Twist E-Stop button clockwise to reset it.
13. Loosen downfeed selector knob slightly, to
engage coarse downfeed lever.
14. Rotate mode switch to "Tap."
15. Press "Left" button. Spindle should rotate
clockwise.
Note: Spindle will not engage if "Right" but-
ton is pressed while in Tap mode.
16. Use coarse downfeed lever to move spindle
down. Spindle should rotate clockwise.
17. Continue to move spindle down until it reach-
es bottom of depth stop—spindle should
momentarily stop, then rotate counterclock-
wise.
18. Use coarse downfeed lever to move spindle
all the way up.
Congratulations! The Test Run is complete.
Continue to the next subsection, Spindle Bearing
Break-In.
5. Turn high/low range knob to “L” and spindle
speed knob to “2” (see Figure 13). This
selects a spindle speed of 220 RPM (refer to
spindle speed chart on headstock).
Note: When switching between gears, it may
be necessary to rotate spindle by hand so
gears will align and engage.
6. Twist E-stop button clockwise until it pops out
(see Figure 13)—this resets the button and
enables power to control panel and motor.
7. Press "Left" button (see Figure 13). Spindle
should rotate clockwise (as viewed from top)
and machine should run smoothly with little to
no vibration or rubbing noises.
8. Press "Off" button and wait for spindle to
completely stop.
9. Press "Right" button. Spindle should rotate
counterclockwise (as viewed from top).
10. Press E-stop button and wait for spindle to
completely stop.
Figure 13. Location of control panel and spindle
speed controls.
E-Stop
Button
High/Low
Range Knob
Spindle
Speed Knob
Mode
Switch
Off
Button
Spindle
Direction
Buttons