Filter
Top Products
STORe [:CONFig]
Command :MMEMory:STORe[:CONfig] <name>[,<msus>],
<description>[,<module>]
The STORe command stores configurations onto a disk. The [:CONFig]
specifier is optional and has no effect on the command. The <name>
parameter specifies the file on the disk. The <description> parameter
describes the contents of the file. The optional <module> parameter allows
you to store the configuration for either the system or the modules. If the
optional <module> parameter is not specified, the configurations for the
system, modules, and any installed software options are stored.
<name> A string of up to 10 alphanumeric characters for LIF in the following form:
NNNNNNNNNN
or
A string of up to 64 alphanumeric characters for DOS in one of the following
forms:
NNNNNNNN.NNN when the file resides in the current directory or
\NAME_DIR\FILENAME when it does not reside in the current directory
<msus> Mass Storage Unit specifier. INTernal0 for the hard disk drive and
INTernal1 for the flexible disk drive.
<description> A string of up to 32 alphanumeric characters
<module> An integer, –2 through 5 for the HP 16500C alone. –2 through 10 with an
HP 16501A connected.
Example OUTPUT XXX;":MMEM:STOR ’DEFAULTS’,’SETUPS FOR ALL MODULES’"
OUTPUT XXX;":MMEMORY:STORE:CONFIG ’STATEDATA’,INTERNAL0,
’ANALYZER 1 CONFIG’,1"
The appropriate module designator "_X" is added to all files when they are
stored. "_X" refers to either an __ (double underscore) for the system or an _(A
through E) for an HP 16500C alone or an _(A through J) with an HP 16501A
connected.
MMEMory Subsystem
STORe [:CONFig]
12–23