Filter
Top Products
Lockout Command
To lockout the front-panel controls, use the SYSTem command LOCKout.
When this function is on, all controls (except the power switch) are entirely
locked out. Local control can only be restored by sending the :LOCKout
OFF command.
Hint Cycling the power will also restore local control, but this will reset the Logic
Analysis System to the power-on defaults and purges any acquired data in
the acquisition memory of all the installed modules.
See Also For more information on this command see chapter 11, "SYSTem Subsystem."
Programming Over LAN
Lockout Command
4–13