HP (Hewlett-Packard) A3311A Tool Storage User Manual


 
ii
Notice
Copyright © 1999 Hewlett-Packard Company
The information contained in this document is subject to change without notice.
Hewlett-Packard Company makes no warranty of any kind with regard to this material, including, but not
limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard
shall not be liable for errors contained herein or for incidental or consequential damages in connection
with the furnishing, performance, or use of this material.
This document contains proprietary information, which is protected by copyright. All rights are reserved.
No part of this document may be photocopied, reproduced, or translated to another language without the
prior consent of Hewlett-Packard.
Typographical Conventions
NOTE! Notes contain important information.
CAUTION! Caution messages indicate procedures which, if not observed, could result in
damage to your equipment or loss of your data.
WARNING! Warning messages indicate procedures or practices which, if not observed,
could result in personal injury.
About this Manual
This manual describes the installation, operation, and service of the HP A3311A deskside, A3312A field
rackmount, and A3312AZ factory rackmount storage systems.
Trademark Credits
TORX hardware is used in this product. TORX hardware requires the use of special drivers. In this
manual, any reference to TORX hardware will be accompanied by the required driver size (for example,
“T-15”).
TORX is a product of the Camcar Division of Textron, Inc.