Filter
Top Products
Troubleshooting & Diagnostics
Module Replacement Procedures
56
Troubleshooting
SE Disk Module Replacement Procedure (HP 3000 Series 900)
CAUTION! The new disk module must be of the same capacity and model as the module
being replaced.
1. Shut down the host then power-off the storage system.
2. Remove the disk module from the storage system.
3. Install a new disk module with the same model and capacity as the failed disk module.
4. Power-on your computer, then power-on the storage system. If your boot device p the storage system,
you may need to reboot your computer
SE Disk Module Replacement Procedure (HP 9000 Series 700, C-Series, J-Series)
1. Shut down the host then power-off the storage system.
2. Remove the disk module from the storage system.
3. Install a new disk module with the same model and capacity as the failed disk module.
4. Power-on the storage system and reboot the host.
5. Perform an ioscan to ensure that the host recognizes the new disk module.
SE Disk Module Replacement Procedure (HP 9000 Series 800)
1. Shut down the host. The storage system can remain operating while you replace the disk module.
2. Remove the disk module from the storage system.
3. Install a new disk module.
4. Power-on the storage system and reboot the host.
5. Perform an ioscan to ensure that the host recognizes the new disk module.