Filter
Top Products
Connecting the VA-2002 Multistandard Logo Generator
7
6 Connecting the VA-2002 Multistandard Logo Generator
To connect the VA-2002 Multistandard Logo Generator as the example in
Figure 2 illustrates, do the following
1
:
1. Connect a composite video source (for example, a composite video VCR) to
the CV BNC INPUT connector.
2. Connect an s-Video source (for example, an s-Video S-VHS) to the Y/C 4p
INPUT connector.
3. Connect the CV BNC OUTPUT connector to a composite video acceptor (for
example, a composite video recorder).
4. Connect the Y/C 4p OUTPUT connector to an s-Video acceptor (for example,
an s-Video projector).
5. Connect the CV BNC MONITOR connector to a composite video acceptor
(for example, a display).
6. Connect the Y/C 4p MONITOR connector to an s-Video acceptor (for
example, a display).
7. Connect the power cord (not shown in Figure 2).
8. If required, connect a PC
2
for use with the VA-2002 Remote Control program
that lets you remotely transfer a logo to the VA-2002 via RS-232, as well as
control certain functions
3
and verify information
4
, as section 9.1 describes.
1 Switch OFF the power on each device before connecting it to your VA-2002. After connecting your VA-2002, switch on its
power and then switch on the power on each device
2 Use a flat-cable (that is, one-to-one uncrossed connections) without a null-modem adapter to connect the RS-232 DB9 port
on your PC to the RS-232F DB9 rear panel port on the VA-2002
3 That is, turn a logo On or Off, as well as delete a logo or all the logos simultaneously
4 That is, memory, size, system information, and version number