Filter
Top Products
Using the VA-2002 Logo Finalizer and Upload Program
17
8. Overwrite the word “unnamed”
1
by typing a new name in its place (optional)
and insert a floppy disk in the floppy disk drive on your computer and click
Continue.
The logo is saved on the floppy disk with the file name: “logo.Igo”.
Since a logo is always saved with the identical file name and file name
extension, you can only save one logo on the same floppy disk at any time,
otherwise saving an additional logo would replace the previous one.
9. Remove the floppy disk from the floppy disk drive on your computer and
insert it in the floppy disk drive
2
on the VA-2002. Follow the instructions
outlined in section 10.2.2.1 that describe how to load a logo.
8.3 Adding Transparency to a Logo
Add transparency to an inserted logo to enable the viewer to see what is being
broadcast behind that logo. Generating a solid logo over part of the screen will
block out that part of the viewing area. For example, compare the solid logo
illustrated in Figure 13 with the transparent logo illustrated in Figure 15:
Figure 15: Transparent Logo on the Center Right Side of the Screen
To add transparency to a logo or part of a logo, already inserted, using the
VA-2002 Logo Finalizer and Upload program, do the following:
1. From the Transparency menu, select the Edit command.
The Set Transparency box appears, as Figure 16 illustrates:
1 The word “design” would appear automatically instead of “unnamed” if the Unnamed – VA-2000 window was saved as
“design. lpj– VA-2000” (see step 4)
2 Item 9 on the front panel in Figure 1