Filter
Top Products
STACKING
Classic I machines CANNOT be stacked.
TILTING
Place the machine on a secure, level surface whenev-
er you use it or store it. Any surfaces you place it on
other than the ground must be firm, non-skid, and
structurally sound.
The gasoline engine is designed to run in a level posi-
tion for best performance. If you do operate it at a slight
angle, be sure to check the oil regularly and keep the
oil level at the FULL mark as it would be in its normal
level condition. Also, fuel capacity will be a little less at
an angle.
LIFTING
The Classic I weighs 1370 lb./621 kg. A lift bail is
provided for lifting with a hoist.
FALLING EQUIPMENT can
cause injury.
Do not lift this machine using lift bail if
it is equipped with a heavy accessory
such as a trailer.
Lift only with equipment of adequate lifting capacity. Be
sure machine is stable when lifting.
HIGH ALTITUDE OPERATION
It may be necessary to derate welder output at higher
altitudes. Some engine adjustment may be required.
Contact a Continental Service Representative.
PRE-OPERATION ENGINE SERVICE
Read and understand the information about the gaso-
line engine in the
Operation
and
Maintenance
sec-
tions of this manual before you operate the Classic I.
Keep hands away from the engine muffler or HOT
engine parts.
• Stop the engine when fueling.
• Do not smoke when fueling.
• Remove the fuel cap slowly to release pressure.
• Do not overfill the fuel tank.
• Wipe up spilled fuel and allow the fumes to clear
before starting the engine.
• Keep sparks and flame away from the fuel tank.
OIL
The Classic I is shipped with the engine
filled with SAE 10W-30 oil. This should be
fine for most ambient operating temperature condi-
tions. See the engine operation manual for specific
recommendations. CHECK THE OIL LEVEL BEFORE
YOU START THE ENGINE. This is an added precau-
tion. When full, the oil level should be up to but not over
the FULL mark on the dipstick. If it is not full, add
enough oil to fill it to the full mark. DO NOT overfill.
For more oil fill and service information, see the
Maintenance
section of this manual.
FUEL
Fill the fuel tank with clean, gasoline only.
The Classic I has a 15 gallon (57 liter) fuel
tank with a top fill and fuel gauge mounted
on the control panel. See the
Operation
and
Maintenance
sections of this manual
for more details about fuel.
BATTERY CONNECTIONS
The Classic I is shipped with the negative battery cable
disconnected. Before you operate the
machine, make sure the
IGNITION switch is in the OFF position and
attach the disconnected cable securely to the battery
terminal. If the battery is discharged and won't start the
engine, see the battery charging instructions in the
Maintenance
section.
INSTALLATION
A-4 A-4
CLASSIC I
WARNING
WARNING
–+
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC