Filter
Top Products
TROUBLESHOOTING & REPAIR
F-42 F-42
CLASSIC I
FIGURE F.20 – FRONT PANEL FASTENER REMOVAL
BOLTS / NUTS / WASHERS (2)
BASE MOUNTING BOLTS (4)
MIDDLE SCREW (1)
23. Using the 1/2” wrench, remove the two bolts,
nuts, and washers that hold the front panel
assembly to the horizontal rails. (There is
one on each side.) See Figure F.20.
24. Using the 9/16” wrench, remove the four
bolts, nuts, and washers from the bottom of
the front panel assembly. These four bolts
mount the front to the base. (There are two
on each side.) See Figure F.20.
25. Using the 3/8” nut driver, remove the screw
from the lower middle of the front panel. See
Figure F.20.
26. Carefully remove the front panel assembly.
MAIN GENERATOR FRAME REMOVAL
AND REPLACEMENT (continued)
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC