Filter
Top Products
OPERATION
B-10 B-10
CLASSIC I
TABLE B.1
RANGE SETTINGS FOR WIRE SIZE/SPEED
Diameter (inches) Wire Speed Range Appropriate Current Range
(inches/minute)
.035 80-110 75 to 120 Amps
.045 70-130 120 to 170 Amps
.068 40-90 125 to 210 Amps
TO USE THE CLASSIC I FOR DC WIRE
FEED WELDING (CONSTANT VOLTAGE)
WITH WIRE FEED MODULE:
1. Connect the LN-25 Wire Feeder. Follow the instal-
lation instructions provided with the wire feeder.
2. Set the wire feeder and Classic I for CV operation.
3. Start the engine. See
Engine Operation
in this
section of the manual.
4. Set the Idler Switch to "AUTO."
5. Set the CURRENT RANGE SELECTOR to a set-
ting appropriate for your wire size and wire feed
speed. See Table B.1 for recommended settings.
6. Set the VOLTAGE ADJUSTMENT to the setting
that gives the best arc characteristics for the range
selected.
7. Pull the gun trigger.
AUXILIARY POWER
Be sure that any electrical equipment plugged into the
generator DC power receptacle can withstand a ±10%
voltage variation.
The DC auxiliary power, supplied as a standard, has a
rating of 1.75 kw of 120V DC power.
The rating of 1.75 kw permits a maximum continuous
current of 15 amps to be drawn from the 120 volt recep-
tacle.
An optional power plug kit is available. See the
Accessories
section of this manual.
WARNING
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC